Capping
A region of negative buoyancy below an existing level of free convection (LFC) where energy must be supplied to the parcel to maintain its ascent. This tends to inhibit the development of convection until some physical mechanism can lift a parcel to its LFC. The intensity of the cap is measured by its convective inhibition. The term capping inversion is sometimes used, but an inversion is not necessary for the conditions producing convective inhibition to exist.
Capping Inversion
Alternate term for Cap; a layer of relatively warm air aloft, usually several thousand feet above the ground, which suppresses or delays the development of thunderstorms. Air parcels rising into this layer become cooler than the surrounding air, which inhibits their ability to rise further and produce thunderstorms. As such, the cap often prevents or delays thunderstorm development even in the presence of extreme instability. However, if the cap is removed or weakened, then explosive thunderstorm development can occur.

The cap is an important ingredient in most severe thunderstorm episodes, as it serves to separate warm, moist air below and cooler, drier air above. With the cap in place, air below it can continue to warm and/or moisten, thus increasing the amount of potential instability. Or, air above it can cool, which also increases potential instability. But without a cap, either process (warming/moistening at low levels or cooling aloft) results in a faster release of available instability - often before instability levels become large enough to support severe weather development.

You can either type in the word you are looking for in the box below or browse by letter.

Search:

Browse by letter:

#  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z